Linux kernel newbies em português

During drilling, the Branch KOSUN Machinery Manufacturing mud solids control system will be directly connected to the mud pump outlet for discharge of mud after four solid control treatment, which can effectively maximize the recovery of mud and minimize emissions of waste. Such effective recycling at the source of the mud, reducing waste emissions.

Vertical Centrifuge is a very common Centrifuge which is a Vertical Model. Vertical Centrifuges are available in Top Discharge & Bottom Discharge. Vertical Centrifuge is widely used in al industries for seperation of Solid from Liquid.

Baroid designs our VCD/Centrifuge packages to provide safe and efficient solutions to customer challenges and to bring added value to drilling operations:

Biological drilling waste treatment describes degradation and mineralization of pollutants in drilling waste by bacteria growth, reproduction and internal respiration introduction of degrading bacteria and nutrients with the introduction of degrading bacteria and nutrients. It also takes advantage of biological characteristics in practical operations such as, liquid/solid separation by means of bios and degradation by means of adding microbial flocculant.

1.Completion Drilling of Drilling Waste Generation and Classification

For drilling mud shale shaker, the shale shaker screens is anther mainly device, it mainly can remove the solids that are larger than the screen mesh openings. The drilling mud with small solids would flow through the screen meshes, and down to the mud tank for the further purification. while the large solids or the cuttings would stay on the screen, and be vibrated and flow to the discharge end of the shaker basket.

KOSUN designs and manufactures Linear Motion Shale Shaker, and produces shale shaker screens by our factory. KOSUN Shaker ScreenFactory is located in the largest solids control system center, KOSUN also supplies replacement shale shaker screen. By screen mesh layer, KOSUN usually supplies 2-layer or 3-layer shaker screens.

The vacuum degasser is highly efficient in solids control system. Its unique design assures reliable continuous operation and the highest level of continuous performance available without the need for helium degassing. Up to five solvent lines may be degassed simultaneously by one unit. The extremely low internal volume of each teflon AF channel offers very quick equilibration and very short start-up times compared with PTFE degassing channels which have the same degassing efficiency.

Biological drilling waste treatmentdescribes degradation and mineralization of pollutants in drilling waste by bacteria growth, reproduction and internal respiration introduction of degrading bacteria and nutrients with the introduction of degrading bacteria and nutrients. It also takes advantage of biological characteristics in practical operations such as, liquid/solid separation by means of bios and degradation by means of adding microbial flocculant.

Mud Cleaneris a key member of solid control equipments of drilling fluid that efficiently removes silt sized particles between 20~74 micron cut.It is comprised of one shale shaker,one desander and on desilter. It can efficiently handle the shale shake underflow, which can lead to high drilling speed with low cost.

Drilling decanter centrifuge, also referred to as a brand new type of horizontal decanter centrifuge, is one of the most important solid/liquid separation equipment in a oilfield solids control system. It can integrate each of the working procedures-feeding, centrifugal settling, unloading, and so on.

Desanderand desilter square measure consisted of hydrocyclones, high flow pipes and alittle sedimentary rock shaer at very cheap. For desanders and dust desilters, only 1 vibration motor is employed to drive the screen basket. whereas for top economical it'd would like 2 motors. There would be equipped with 2 10″ or 12″ iron hydrocyclones for desander even as the solids ought to be separated is comparatively massive, and embrace some sands within the mud.