Linux kernel newbies em português

As one of the important equipment for solid/liquid separation system, the drilling mud cleaner, also called desander and desilter assembly, mainly consists of three parts including desander, desilter and the underflow screen. It can achieve separation of two stage with the hydrocyclone mounted over the shale shaker. Compared with the independent desander and desilter, the product has much higher working efficiency. Same as the shale shaker in function, the equipment is designed rationally with compact structure, small volume and powerful performance.
The Maintenance of Drilling Mud Cleaner
1. Vibration motor maintenance
(1) Clean dust on shell regularly.
(2) Before operating, the bolts must be checked to confirm whether there is loose or not. Otherwise, we must screw bolts tight before running shaker.
(3) Inspect the cable, whether it is worn, held down, crushed, etc.
(4) The vibration motor should be under good lubrication during operation motors before being fixed on shaker, the bearing is filled with SKF specific lubricate grease, the temperature range is -40 ~ 200℃.
2. Shaker screen maintenance
(1) Before every shut off, the shaker should run without any load for 5-10 minutes, at the same time, use clean water to flush screen clean.
(2) Every time finish operation, the shaker frame and screen should be flushed by water. Pls replace new screen or repair the damaged screen once it is found damage, otherwise large cutting may drop into the clean mud and influence the following process.
3. Electric cabinet maintenance
4. Wear parts replacement
The user should check and replace the wear parts regularly, except for vibration motor, shaker screen, electric cabinet mentioned above. Locking wedge, composite vibration spring, sealing rubber should be replaced at once.
KOSUN, with more than 20 years experience of designing and manufacturing solids control equipment used in oil & gas extraction, provides full range of drilling waste management equipment and solids control equipment mainly including shale shaker,decanter centrifuge, desander, desilter, mud cleaner,decanter centrifuge ,vertical cuttings dryer ,vacuum degasser and complete solids control system. KOSUN reduces the drilling waste at well source where solids control equipment are involved. KOSUN's advanced engineers will collaborate with you to fully understand the project priorities and customize the proper solids control equipment for benefit maximization and reduction of local environmental pollution.