Linux kernel newbies em português

KOSUN Hi-G shaker recovers drill fluids cuttings from water-based and oil-based drilling fluids, can make the proportion of the liquid phase in the drilling to below 10%, can significantly reduce the cost of the waste discharge, and is particularly effective in the oil base mud cuttings.

It mud be noted that until the advent of KOSUN Hi G technology, the traditional method for control of OOC was install a cuttings wash/cleaning system. This was not only an expensive solution. But in some cases a very inefficient one, which sometimes reported higher figures than that being discarded from the shaker. As it is, the Hi G dryer requires minimal supervision. Together with its low operation costs and significant savings in fluid, it is an attractive alternative to any cuttings cleaning system. It can also be utilized well with high cost “pseudo” mud and/or “closed loop” systems.

Another major benefit of the Hi G dryer technology, sometimes overlooked, is the elimination of whole mud losses from the shaker. This historically has ensured that the shakers were never run at their optimum capacity and thus the solids control system efficiency was adversely affected. Incorporating the Hi G dryer down steam allows the shakers to be run close to maximum capacity without the concern of whole mud losses.

Hi-G Dryer is also called Hi-G shaker as it is one kind of shale shaker which is as drilling mud solids control equipment. But Hi-G dryer is used to treat drilling waste in drilling fluid processing system.