Linux kernel newbies em português

Raymond mill is one of the important milling equipment for deep processing of non-metallic minerals. Because of the Raymond mill stable performance, strong adaptability, high ratio of performance to price, since the introduction of our country for 20 years, has been widely used in the processing of non-metallic minerals. However, with the recent non-metallic minerals in the ultrafine powder application areas of extensive development, Raymond mill has been applied the maximum range, is one of the most widely used of all mill.

Raymond mill process characteristics

1, the fineness of product is low, the General Raymond grinding fineness is generally below 500 meshes, these devices can only occupy the lower powder application market.

2, mechanical failure rate is high, power consumption, noise, pollution

3, the low efficiency of the system, collection system separation effect of the product is not ideal, a large number of fine powder is not effectively collected and repeat the cycle in the system caused by the power waste

4, the host bellows duct design mistakes, into larger particles in the material grinding zoneand future and particle grinding broken is often thrown into the bellows aggregation tail incochlear box, and continue to extend forward, the wind gradually decrease, easy causetraffic jams, no powder or less powder, affecting production.

Raymond mill is widely used in cement plant, mine production. Raymond mill with superbtechnology and unique performance, and continuously meet the diverse needs of the market. Raymond mill production process, there are some reasons can influence the production efficiency is reduced, the following from our technical staff to introduce.

1) the product composition: fine powder with more products, should advance once sieve,avoid the powder is attached inside the Raymond mill, conveying;

2) moisture products: Raymond Mill of large moisture products not too interested, in general, the product moisture content inside Congress adhesion of Raymond mill,congestion will cause material conveying process, greatly reduces the efficiency of Raymond mill;

3) the viscosity of the products: products the greater the viscosity of the adhesive force is bigger, will affect the efficiency of Raymond mill;

4) the hardness of products: in general, a hard material more difficult to mill, with the hardness of material increase mill the difficulty will increase, and will wear Raymond mill;

5) the wear resistance and the better the performance of Raymond mill is adopted, so the ability of Raymond mill is bigger, can better grinding products.

Raymond mill production efficiency is not unalterable, should pay attention to the details of the work, maintenance better, more than just improve the Raymond mill production efficiency of the important points, the actual production and more fine details need to pay attention to. Master Raymond mill operation and matters needing attention, will greatly improve the production efficiency.