Linux kernel newbies em português

In home decoration, basically we will do some hanging cabinet, closet like furniture, especially in the kitchen is more common. Some hanging cabinet, closet in use for some time, there will be distortion cleats, even decadent mildew. Exclude pipeline, of course, because the timber walls caused by damp conditions after water seepage. To sum up mainly by the following aspects (1) Water decoration materials with high moisture content itself. Decorative construction, walls, floors wet work, walls, floors not dry on the installation of hanging cabinet, closet, walls, floors distribute moisture is absorbed wooden decoration materials. Cabinet installation drains, the sealing has been lax or ground floor closet in wpc timber price the wet state wood materials to absorb. Wall wood materials have not been embalmed. Wood wall portion of the water can not be distributed. In order to eliminate hidden dangers, construction should take appropriate measures: the moisture content of water in the southern region of decoration materials should be controlled below 15%, or heating in northern areas should be controlled below 12%. Be walls, substantially dry ground after, then install hanging cabinet, closet. Installation hanging cabinet, former closet, wall to enter the site, by the wall of water quality material easy to damp parts should be brushed preservatives. Cabinet drains interface should be sealed to prevent water overflowing. Pelton, apply sealant around the basin, overflow water along the cracks of wood material to prevent water infiltration. Hanging cabinet, closet due to the installation on the wall, after the wood to absorb moisture, water can not distribute, so the wood surface cabinet, cabinet plywood and other legislation should paint or soak in water. Hanging cabinet, why would deform some closet doors hanging cabinet, closet doors in use for some time will be bent, can not even switch. Why is there such a situation? It boils down to is 2x6x36' lumber lowes inseparable from a word "water". There are several reasons: wood moisture content is too low or too high. The moisture content is too low, it will swell deformation to absorb moisture, the moisture content is too high, shrinkage after drying. Front doors paint brush, brush the inside is not the end result of one-sided brush the surface of wood materials absorb moisture, dried and evaporated, making the door bending. Coupled with the general hanging cabinet, closet doors is thin, the thinner the more can not stand the impact of the external environment, easily deformed. Because the wood material itself factors, doors with moisture and temperature changes and deformation. For the above, in the hanging cupboard, closet production process should be strengthened control these aspects. The moisture content of wood in general, in the southern region is relatively high air humidity should be controlled at around 15%, in the North and drier areas should be controlled at about 12%, generally should not be less than 8%, so as not to affect the absorption of moisture switch. Brush the paint timber in order to protect them from erosion of the external environment. Thus hanging cabinet, inside and outside the upper and lower surfaces plastic composite outdoor table top material crowns and even closet doors doors must paint, plastic coated surface as if it should be a full stick. Also leaf thickness not less than 20mm. Production of leaf material should adopt blockboard, multi-layer plywood, such as the use of wood, you should avoid using deformable timber (such as ash) and parts (such as the log edges).