Linux kernel newbies em português

Hi-G Dryer is also called Hi-G shaker http://www.kosun.us/drilling-waste-management/hi-g-dryer.html as it is one kind of shale shaker which is as drilling mud solids control equipment. But Hi-G dryer is used to treat drilling waste in drilling fluid processing system. KOSUN Hi-G shaker recovers drill fluids cuttings from water-based and oil-based drilling fluids, can make the proportion of the liquid phase in the drilling to below 10%, can significantly reduce the cost of the waste discharge, and is particularly effective in the oil base mud cuttings.

It mud be noted that until the advent of KOSUN Hi G technology, the traditional method for control of OOC was install a cuttings wash/cleaning system. This was not only an expensive solution. But in some cases a very inefficient one, which sometimes reported higher figures than that being discarded from the shaker. As it is, the Hi-G dryer requires minimal supervision. Together with its low operation costs and significant savings in fluid, it is an attractive alternative to any cuttings cleaning system. It can also be utilized well with high cost “pseudo” mud and/or “closed loop” systems.

With advanced KOSUN Hi-G technology, the Hi-G dryer shaker is efficient in recovering more oil based drilling fluids and the Oil On Cuttings (OOC) figures is significantly reduced. Another benefit is the elimination of whole mud losses from the traditional shale shaker. So with the use of Hi-G dryer shaker in the down stream of mud system, it can allows the shakers to run at their maximum capacity without the concern of the mud loss of the mud system. This is why the Middle East drilling contractor cone to us for the Hi G dryer for their existing mud system.