Linux kernel newbies em português

Superfine raymond mill is widely used in the national economy of the basic department. Superfine Raymond mill is used for a long time, the dust of superfine Raymond Mill sealing ring wear, consumption, resulting in high cost of equipment.

Therefore, the sealing ring can be repaired transformation of dust.

Dustproof sealing ring wear reason is dustproof sealing ring in the movable cone, the dust cover can move freely and sliding. Due to mobile dustproof sealing gap between the ring and the dust cover more than permissible clearance.

The superfine Raymond mill dust seal of wear ring, conducted a comprehensive analysis, using the corresponding transformation.

1) the excess wear dustproof need to replace the sealing rings for the measurement of alignment, processing out of the groove width, depth of L 3mm 7.8mm on the inner side of the work surface.

2) with 8.5mm rubber ring inlaid in the groove, and connected with a joint press.

3) to clean up the embedded flash groove rubber ring, rubber ring to press. Lifting the careful not to strip rubber ring groove.

After the transformation of the superfine raymond mill dustproof sealing ring when in use should pay attention to the following points:

The runtime should always check for leaks, and the regular replacement of rubber ring. General in the replacement of superfine Raymond mill grinding roller liner when the regular replacement of rubber ring.

The need to pay attention to wear dustproof ring, if wear large, dustproof sealing ring and replace. Each year about 1 dustproof sealing ring can be replaced.

Dust on superfine Raymond mill ring repair after the transformation, can effectively prevent the dust and dirt into the crusher lubricating system, which can meet the requirement of equipment operation, operation cost and saves the superfine Raymond Mill equipment.