Início › Blogs › Blog de jackson0

The Reason For Decreased Manufacture Of Raymond Mill Equipment

qui, 04/16/2015 - 02:46 — jackson0

The so-known as raymond mill equipment mainly refers back to the milling equipment, mainly employed for barite, calcite, feldspar, talc, marble, limestone, dolomite, fluorite, lime, triggered clay, triggered carbon, bentonite, kaolin, cement, phosphate rock, gypsum, glass, insulation materials with hardness under 9.3 fine powder processing, mugginess below 6% non inflammable and explosive mineral, chemical, construction along with other industries greater than 280 types of materials. In using process, equipment production will decline, the reason for this phenomenon is principally within the following six points.

First, within the grinding material, grinding materials to select moderate hardness, the hardness of materials, the yield is low, not just that, high hardness, put on around the machine, the alternative of putting on parts and faster, when the materials are of high hardness grinding would be to choose high hardness coffee grinder grinding.

Second, the fabric in grinding material humidity generally at 10% moisture content, when the water submissions are high, then your dry milling, otherwise the fabric within the raymond mill internal will adhere around the machine, the device accident blocked.

Third, in the option of grinding material, usually with jaw crusher, crushing machine along with other equipment, material particle size crushed to fine contaminants as you possibly can, to ensure that the grinding time can yield greater.

4th, crushing the fabric could be damaged into fine contaminants, but when damaged when an excessive amount of powder, it's important to improve the screen to fine powder, if an excessive amount of, will modify the host raymond mill.

Fifth, the low the viscosity from the material yield is high, choice of material grinding low viscosity.

Sixth, the grinding curler put on parts procurement, mill ring, good abrasion resistance, therefore the alternative parts a lot sooner, lessen the frequency of maintenance, will greatly enhance the grinding production.